beautypg.com

Engine starting/stopping, Accessory positions with engine off, Getting started – Jeep 2012 Grand Cherokee SRT - User Guide User Manual

Page 17

background image

Engine Starting/Stopping

Starting

• With a valid Keyless Enter-N-Go™

Key Fob inside the vehicle.

• Place the shift lever in PARK or

NEUTRAL.

• While pressing the brake pedal,

press the ENGINE START/STOP
button once. If the engine fails to
start, the starter will disengage
automatically after 10 seconds.

• To stop the cranking of the engine

prior to the engine starting, press
the button again.

Stopping

• Place the shift lever in PARK.

• Press the ENGINE START/STOP button once. The ignition switch will

return to the OFF position.

If the shift lever is not in PARK, the ENGINE START/STOP button must

be held for two seconds and vehicle speed must be above 5 mph
(8 km/h) before the engine will shut off.

Accessory Positions with Engine Off

NOTE:
• The following functions are with the driver’s foot OFF the Brake Pedal

(Transmission in PARK or NEUTRAL Position).

Starting With The Ignition Switch In The OFF Position:

• Press the ENGINE START/STOP button once to change the ignition

switch to the ACC position.

• Press the ENGINE START/STOP button a second time to change the

ignition switch to the ON/RUN position.

• Press the ENGINE START/STOP button a third time to return the ignition

switch to the OFF position.

NOTE:
• If the ignition switch is left in the ACC or ON/RUN (engine not running)

position and the transmission is in PARK, the system will automatically time out
after 30 minutes of inactivity and the ignition will switch to the OFF position.

OFF

RUN

ACC

Press

Press

Press

GETTING STARTED

15

This manual is related to the following products: