Jeep 2011 Liberty - Owner Manual - Manual (Page 182)

Enabling And Disabling ParkSense
ா
ParkSense ௡ can be enabled and disabled with a switch
located in the switch bank of the instrument panel or
through the Customer-Programmable Features section of
the EVIC. The available choices are: OFF, Sound Only, or
Sound and Display. Refer to “Electronic Vehicle Informa-
tion
Center (EVIC)/Personal Settings (Customer-
Programmable Features)” in “Understanding Your In-
strument Panel” for further information.
When the ParkSense
௡ switch is pressed to
disable the system, the instrument cluster will
display the “PARK ASSIST OFF” message for
approximately five seconds. Refer to “Elec-
tronic Vehicle Information Center (EVIC)” in “Under-
standing Your Instrument Panel” for further information.
When the shift lever is moved to REVERSE and the
system is disabled, the EVIC will display the “PARK
ASSIST OFF” message for as long as the vehicle is in
REVERSE.
The ParkSense
௡ switch LED will be ON when Park-
Sense ௡ is disabled or defective. The ParkSense௡ switch
LED will be OFF when the system is enabled.
Service The ParkSense
ா
Rear Park Assist System
When the ParkSense ௡ Rear Park Assist System is mal-
functioning, the instrument cluster will actuate a single
chime, once per ignition cycle, and it will display the
“SERVICE PARK ASSIST SYSTEM” message. Refer to
“Electronic Vehicle Information Center (EVIC)” in “Un-
derstanding Your Instrument Panel” for further informa-
tion. When the shift lever is moved to REVERSE and the
system has detected a faulted condition, the EVIC will
display the “SERVICE PARK ASSIST SYSTEM” message
for as long as the vehicle is in REVERSE. Under this
condition, ParkSense
௡ will not operate.
If “SERVICE PARK ASSIST SYSTEM” appears in the
EVIC, see your authorized dealer.
180 UNDERSTANDING THE FEATURES OF YOUR VEHICLE