Jeep 2011 Liberty - Owner Manual User Manual

Page 117

Call Termination
To end a call in progress, momentarily press the
button. Only the active call(s) will be terminated and if
there is a call on hold, it will become the new active call.
If the active call is terminated by the phone far end, a call
on hold may not become active automatically. This is cell
phone-dependent. To bring the call back from hold, press
and hold the

button until you hear a single beep.

Redial

• Press the

button to begin.

• After the “Ready” prompt and the following beep, say

“Redial”.

• The Uconnect™ Phone will call the last number that

was dialed from your mobile phone.

NOTE:

This may not be the last number dialed from the

Uconnect™ Phone.

Call Continuation
Call continuation is the progression of a phone call on the
Uconnect™ Phone after the vehicle ignition key has been
switched to OFF. Call continuation functionality avail-
able on the vehicle can be any one of three types:

• After the ignition key is switched to OFF, a call can

continue on the Uconnect™ Phone either until the call
ends, or until the vehicle battery condition dictates
cessation of the call on the Uconnect™ Phone and
transfer of the call to the mobile phone.

• After the ignition key is switched to OFF, a call can

continue on the Uconnect™ Phone for a certain dura-
tion, after which the call is automatically transferred
from the Uconnect™ Phone to the mobile phone.

• An active call is automatically transferred to the

mobile phone after the ignition key is switched to OFF.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

115