ISSPRO R82733 - Manual

PERFORMAX
Form No. IS150 (Rev. A 03/11/2008 )
ISSPRO, INC.  2515 N.E. Riverside Way  Post Office Box 11177  Portland, Oregon 97211-1899
503-288-4488  800-888-8065  Fax: 503-249-2999
www.isspro.com © 2008 ISSPRO, Inc. All Rights Reserved.
TURBO BOOST PRESSURE GAUGE AND SENSOR
INSTALLATION INSTRUCTIONS
Models: R43133 R43233 R43333 R43433 R52133 R52233 R52333
R52433 R53133 R53233 R53333 R53433 R59133 R59233
R59333 R59433 R68133 R68233 R68333 R68433 R69133
R69233 R69333 R69433 R82133 R82233 R82333 R82433
1  Disconnect batteries. Do not reconnect battery power until system is
fully configured to avoid risk of shock or fire.
2  Install Electronic Signal Processor (ESP) and ESP harness according to
instructions.
I C O N K E Y

CAUTION

Tools may be required

Shown in picture
3  Connect the Pressure Sensor Harness to the ESP Harness as follows:
a. Remove plugs from cavities 1, 2 and 3 of connector B (black) of the ESP.
b. Using a pair of needle nose pliers, pull the orange wedge lock out of connector B.
c. Insert the terminal from the red wire (5V sensor supply output) into cavity 1 of connector B
on the ESP, pushing until it snaps into connector B.
d. Insert the terminal from the black wire (sensor supply ground) into cavity 2 of connector B on
the ESP, pushing it until it snaps in place.
e. Insert the terminal from the green wire (sensor input) into cavity 3 of connector B on the ESP,
pushing it until it snaps in place.
f. Note: Terminals will be close to flush with the top of the connector when fully seated.
g. A firm pull of the wire will confirm whether they are properly seated.
h. Push the orange wedge lock back into position. If any of the wires are not fully seated, the
wedge lock will not insert into position.
i. Reconnect connector B (black) to the ESP.
Figure 1: Connector B top and bottom
view. Shown with plugs and wedge-lock
installed.
Figure 2: Remove plugs and wedge-lock as
shown. Wedge-lock is replaced once wires are
positioned properly.