ISSPRO R82600 - Manual

PERFORMAX
Form No. IS151 (Rev. A 03/11/2008 )
ISSPRO, INC.  2515 N.E. Riverside Way  Post Office Box 11177  Portland, Oregon 97211-1899
503-288-4488  800-888-8065  Fax: 503-249-2999
www.isspro.com © 2008 ISSPRO, Inc. All Rights Reserved.
VOLTMETER GAUGE INSTALLATION INSTRUCTIONS
Models: R43600 R52600 R53600 R59600 R68600 R69600 R82600
1  Disconnect batteries. Do not reconnect battery power until system is
fully configured to avoid risk of shock or fire.
2  Install Electronic Signal Processor (ESP) and ESP harness according to
instructions.
I C O N K E Y

CAUTION

Tools may be required

Shown in picture
3  Connect voltmeter to the ESP. (See ESP instructions for more details on how to do this). Note:
If drilling a mounting hole in a panel to mount this gauge, the hole size should be 2.040”.
4  Secure all wiring so that it does not interfere with moving parts or chafe on sharp edges. This may
be accomplished by routing the wiring within the factory wire harness sheath, using wire ties and
sheathing, and using appropriate grommets when passing through the firewall.
5 No external sensor is required. Sensor is internal to the ESP.