Hybrid Racing WaveTrac LSD - Manual (Page 4)

4
STEP 5:
Using a 12mm socket, remove all of
the 8mm flange bolts that hold the two
halvs of the tranmsission together. All
of the bolts should be loosened in sev-
eral steps before any are removed.
The bolts should be loosened in a criss
-cross patern to avoid uneccessary
stress on the bolts that are still tight.
Reassembly Tips: First install and
hand tighten all of the flange bolts.
Then torque the flange bolts to 20 ft-lb
(27 N-m) in a criss cross patern.
Install Guide
STEP 6B:
Use a set of snap ring pliers to expand
the 72mm snap ring and remove it
from the groove it sits in on the couter-
shaft bearing. The snap ring can not
be removed from the tranmsission at
this point. It only needs to be removed
from the groove it sits in.
Reassembly
Tips: Remember to put the 72mm snap
ring back in the groove on the counter
shaft bearing before screwing the
32mm sealing cap back in. Once in-
stalled, there should be a 3.3-6mm gap
between the tips of the spring clip.
STEP 6A:
Remove the 32mm sealing cap using a
14mm allen wrench. Scrape off any
Honda Bond that is on the mating sur-
faces between the sealing cap and the
transmission.
Reassembly Tips: Re-
member to put the 72mm snap ring
back in the groove on the counter shaft
bearing before screwing the 32mm
sealing cap back in. Also, apply Honda
Bond to the threads of the cap before
reinstalling it.