Craftsman 351.21833 - Manual (Page 10)

STEP 19
INSTALL PUSH STICK
• Insert the push stick into brackets on left side of base.
STEP 20
INSTALL RIP FENCE
• Position rip fence assembly at end of saw. Be certain lock-
ing lever is in UP unlocked position.
• Place rip fence assembly onto rails, positioning clamp over
rear rail and then placing rip fence onto front guide rail.
• Rip fence should now ride freely on rip fence rails. Once
rip fence is completely installed, it should be thoroughly
adjusted.
STEP 21
SAW COMPLETELY ASSEMBLED
10
Figure 33
Figure 35
Figure 34