Hollywood Racks HR1450R SportRider SE 2 Recumbent - Manual (Page 5)

Step 7: Installing bikes on the rack
The bikes should be mounted from inside (1
st
bike) to
the outer bike. The bikes should always be positioned so that
the lowest point on the bike frame’s top tube is close to the
vertical post In the case of long wheel base recumbents, wheels
must not exceed width of side view mirrors. Please note in
some states, wheels must not exceed width of vehicle body.
The bike handlebars should be staggered (first bike’s
handlebars on passenger side, second bike’s handlebars on
driver side, etc.
Lower the vertical post. To adjust the bike’s wheels trays,
loosen the knobs and slide wheel holders along the wheel
support tube so that they are positioned directly beneath each
wheel. Tighten knobs securely after determining correct
position. Rotate the bike’s pedals so that the vertical post can
be raised and secured. Slide the hook down onto the frame.
Use the Velcro strap on the wheel holder per Fig. 7b.
Follow same procedure for second bike. After both bikes are
mounted and secured to the rack, use the additional tie down
straps (item U) to secure bike to rack per Fig. 7C
Tips for carrying woman’s bikes and bikes with slanted top
tubes: Adjust the wheel trays so that the hook will rest in the
bike frame’s top tube and seat tube.
A keyed trailer hitch pin and security cable is included to
help prevent theft of rack and bikes.
Fig. 7a
Fig. 7b
Fig. 7c
5