Casio XJ-A230 - Manual (Page 15)

E-14
Getting Ready
Locate the projector on a desk, table, or stand that is firm and level. Make sure to allow sufficient space
around the sides and back of the projector for proper ventilation.
 The following illustrations show how the projector should be oriented for optimum projection relative
to the screen.
Important! Important! Important!
 You can place the projector on a surface that is angled up to 30 degrees upwards or
downwards during use. Never locate the projector on a surface that is angled more than 30
degrees, or angled at all to the left or right. Such conditions can shorten lamp life, and also
creates the risk of malfunction.
 The projector’s auto keystone correction range is 0 to +30 degrees. If the surface you are
projecting onto is angled downwards from horizontal, use manual keystone correction (page
E-22) to correct the image.
 Turn on the “Option Settings 2  High Altitude” setting on the setup menu when using the
projector in a high altitude (1,500 to 3,000 meters (5,000 to 10,000 feet) above sea level) area
where air is thin. For details, see the User’s Guide on the CD-ROM that comes with the
projector.
NOTE
 The projector can be configured for projection from the back of a screen. For details, see the User’s
Guide on the CD-ROM that comes with the projector.
Setting Up the Projector
Viewed from Above
Viewed from the Side
(XJ-A130/XJ-A135/XJ-A140/XJ-A145)
Viewed from the Side
(XJ-A230/XJ-A235/XJ-A240/XJ-A245)
The center of the projector’s lens should be
aligned with the horizontal center of the screen.
Screen
Make sure the projector is
at a right angle to the
screen.
Screen
Position the projector so
the lens side is at the edge
of the table, etc.
Screen