General Hydroponics EuroGrower - Manual (Page 3)

ASSEMBLY
STEP 1
Place the Panda Reservoir on a level
surface where it will be used. Coat the
inside of the Reservoir grommet with a
thin coating of silicon grease (optional)
and insert Drain Valve into grommet
using a twisting motion.
STEP 2
Attach the Drain Rail Clips by inserting
them into the holes on the Reservoir Lid.
STEP 3
Place the Lid Support in the
center of Panda Reservoir
with the notch over the
center rib and place the
Reservoir Lid on top of
Panda Reservoir. Proper
positioning of Lid Support
will prevent the Reservoir
Lid from sagging.
STEP 4
Position both Drain Rails on top of
the Reservoir Lid and make sure Drain
Rails rest in the Drain Rail Holes in the
Reservoir Lid.
Drain Rail Holes