Gastroback 42408 Design Combo Set - Manual (Page 9)

2. Open the lid by pushing the opening button. Remove foreign objects
out of the kettle. Fill the kettle with the desired amount of water. Always
be sure your kettle is unplugged when you’re filling it or adding more
water to it.
Always fill the kettle with at least 250ml of water and at most up to the
maximum mark 1000/MAX of the water level indicator on the front wall
of the kettle (picture B). When moving the filled kettle keep the kettle in an
upright position to avoid spilling water.
• Too little water will result in the kettle boiling dry and automatically switching OFF.
• Filling above the maximum mark may result in boiling water splashing from the kettle.
IMPORTANT: Your kettle has an automatic shut-off safety feature that protects against
overheating. It will operate if the kettle is switched ON without enough
water in the kettle. If the automatic safety shut-off has occurred, switch the
kettle OFF by pressing the illuminated part of the power button (picture C).
Disconnect the kettle from the power outlet and allow it to cool for 5–10
minutes. Then, refill the kettle with a sufficient amount of water and switch it ON. The kettle
will now boil and shut off as usual.
3. Close the lid. The lid will lock into position when it is pressed down slightly.
IMPORTANT: Always close the lid, before switching on the appliance. Otherwise
power consumption increases significantly.
CAUTION! Only with the lid closed, the kettle automatically switches OFF,
once the water has boiled.
4. Place the kettle onto the power base and insert the power plug in a 230/240V wall
power outlet. The electric contacts of the multi-directional power base will slide into a
corresponding opening in the bottom of the kettle. The power base will work out in any
orientation.
You can turn the kettle on the power base until the handle or the spout will hit the side
of the toaster.
5. Press the power button to switch ON the kettle (picture D). The control
lamp of the power button will illuminate and the heating element starts heating.
WARNING! The exterior of the kettle will get very hot during operation
and even some minutes after switching OFF the appliance. In addition, beware of steam
venting from the lid and spout and hot condensate, especially when opening the lid or
pouring out water. Always keep your hands, face and arm as well as any clothing and
other objects away from the lid and spout of the kettle. Always use the handle for moving
the kettle and take care to keep the kettle level to avoid boiling water pouring out
unintentionally.
6. When the water is boiling the kettle will switch OFF automatically after a few seconds.
After allowing the kettle to cool down for 15–20 seconds, the water can be brought back
27
C
B
Max
Min
D
42408_DesignComboset_Manual_GermanEnglish.qxp 16.06.2008 10:01 Seite 27