Gastroback 42408 Design Combo Set - Manual (Page 10)

to a boil by pressing the power button again.
IMPORTANT: Do not remove the kettle from the power base without switching it
OFF first, by pressing the illuminated part of the power button. The kettle is
switched OFF, if the control lamp of the power button is not illuminated (picture E).
7. To pour the water, lift the kettle from the power base and pour.
NOTE: Use caution when pouring boiling water from the kettle. Do not pour the water
too quickly, as boiling water could splash.
NOTE: Discard the water after first use.
Important: Do not leave remaining water cool down to room temperature in the kettle
to avoid any excessive accumulation of mineral deposits on the interior of the kettle and water
level indicator.
The kettle may be stored on its power base, when not in use to protect the connector pins
from dust and splashes.
If you do not wish to reboil the water, unplug the power base.
WARNING: Always switch OFF the kettle and unplug from power supply,
when the kettle is not in use, to avoid risk of fire and electric shock. DO
NOT leave the power base unattended with the power plug connected to
the power supply.
IMPORTANT: The kettle only works when positioned on the power base and switched
ON at the power button. If there is not enough water in the kettle during operation, the
boil dry cut-out switches OFF the heating element automatically.
IMPORTANT: Always ensure that the power button of the kettle is switched OFF before
connecting the plug to the power outlet.
Dry-out Protection
If there is not enough water in the kettle during operation, the boil dry cut-out switches
OFF the heating element automatically. To reset the appliance:
1. Switch OFF the kettle by pressing the illuminated part of the power button
(picture F) and wait some minutes for the heating elements to cool down.
Then press the opening button to open the lid and slowly fill the kettle with
water. Always keep the water level between the minimum and maximum
water level mark (250 to 1000/MAX) during operation.
2. Close the lid, replace the kettle on the power base and switch ON the kettle.
For additional safety your kettle is fitted with an additional thermal cut out. In the event
of overheating, the kettle will automatically shutdown to prevent further damage. In this
case, take your kettle to an authorised service centre for inspection and repair.
WARNING: Do not attempt to operate the appliance after shutdown by the thermal cut
28
F
E
42408_DesignComboset_Manual_GermanEnglish.qxp 16.06.2008 10:02 Seite 28