Gastroback 42408 Design Combo Set - Manual (Page 8)

• Keep the cord away from hot surfaces, including the stove. When the power cord
warms up during operation or is likely to be damaged, it must be replaced by an authorised
service centre. Do not attempt to repair the power cord!
• Do not immerse the kettle, power base or power cord in water or any other liquid. Do
not spill or drip any liquids on the power base, power cord or switch area of the kettle
to avoid risk of fire and electric shock. When liquids are spilled on the exterior of the
appliance or condensate has built up on the power base, immediately switch OFF the
kettle, unplug the power base and dry the appliance. In this case hand over the appliance
to an authorised service centre for examination.
• Immediately switch OFF the kettle, unplug the power base, if liquid is spilled on the
exterior of the appliance or on the power base or the kettle leaks.
• Use the appliance only with the supplied power base. Do not use the power base unit
for any other purpose. To protect against fire, do not operate in the presence of explosive
and/or flammable fumes or gases.
First use of the Kettle
Carefully unpack the appliance and remove any promotional material attached to the
kettle, but do not remove the warning or model labels on the appliance.
CAUTION! Only fill with pure drinking water. Do not fill any other liquids or foodstuffs
into the kettle and do not add any additional ingredients, such as spices or flavours. Do
not place any foreign objects in the kettle.
WARNING: Always connect the appliance directly to a separately protected mains
power supply wall socket with protective conductor (earth/ground) connected properly. Do not
use any extension cord or multi socket outlet. Use the kettle only with the supplied power base.
Using the Kettle
Before first use, fill the kettle to its maximum level 1000/Max with pure drinking water,
boil according the following instructions and, thereafter, discard the water.
IMPORTANT: Do not place any foreign objects in the kettle.
1. Prepare the power base for operation. Completely unwind the power cord of the
power base, and put the cable in the gab in the brim of the power base. Always place
the appliance on a stable, level, dry, heat-resistant and easy accessible surface. Do not
place the appliance on an inclined surface. Ensure, that the power base will not tilt or
wobble before placing the kettle on it. Otherwise, during operation boiling water could
splash from the kettle and cause scalding and damage.
ATTENTION: Do not handle the appliance or any part of it with violence.
The lid will open automatically, when pressing the opening button
(picture A). Ensure no foreign objects are in the kettle.
26
A
42408_DesignComboset_Manual_GermanEnglish.qxp 16.06.2008 10:01 Seite 26