Gastroback 41402 Mincer Pro - Manual (Page 8)

the leg of the table using a separate cord, to ensure that no one will pull the power cord.
To connect: always connect the appliance to the extension cord first. To disconnect: Always
unplug the extension cord from the power supply first.
• Always handle power cords with care. The pins of the power plug must be smooth and
clean. Always completely unwind the power cord before use. Do not place the appliance
on a power cord. Power cords may never be knotted, twisted, pulled, strained or squeezed.
Do not let the plug or power cord hang over the edge of the table or counter. The power
cord may not touch hot surfaces or sharp edges. Ensure that no one will pull the appliance
by the power cord. Take care not to entangle in the power cord. Always grasp the plug to
disconnect the power cord. Do not touch the appliance or power plug with wet hands when
the appliance is connected to the power supply.
• DO nOT drip or spill any liquids on the housing or power cord. Do not immerse the
appliance or power cord in water or other liquids. Do not pour or spill any liquids on the
housing or power cord. Do not place the appliance on wet surfaces. When liquids over-
flowed or are spilled on the housing or power cord, immediately unplug the appliance.
Thereafter, clean the appliance and let it dry for at least 1 day. (See: ›Care and Cleaning‹)
Do not clean the appliance in an automatic dishwasher.
TeChnICAl SPeCIFICATIOnS
Model: Art. No. 41402 Fleischwolf Pro
Power supply: 220-240 V AC, 50 Hz
Power consumption: 350 W; max locked motor power 1,000 W
Length of power cord: ca. 1.2 m
Weight: ca. 6 kg
Dimensions: (width x depth x height) ca. 41 cm x 16.5 cm x 36.0 cm
OPeRATInG
Before first use
Rinse all the parts of the appliance that come into contact with food with water and clean
them with dishwashing detergent. Operate according to the instructions ›Care and cleaning‹.
Before operating the appliance, insert the plug into the outlet on the body, and the power
supply plug into the socket outlet.
Assembling
wARnInG:
Ensure that the appliance is switched off and the
power cord is unplugged.
1. Place the mincer on a flat, dry surface such as a bench top.
2. Loosen the screw plug on the left side of the mincer turning
it anticlockwise. Firmly secure the worm housing in the opening
for the drive shaft. The opening of the worm housing should be
upright. Hold the worm housing with one hand and insert the
screw plug into the side hole of the motor block. Turn the screw
24