Gastroback 41402 Mincer Pro - Manual (Page 5)

• The work space has to be easily accessible, solid, even, dry and of sufficient size. The
mincer should only be set up on a firm level work surface. never situate the appliance
close to the edge of the working area. Ensure that the power supply cable does not hang
down from the work surface as it could be easily pulled, particularly by small children,
thereby causing serious accidents.
• never cover the air box on the back of the appliance. The air has to able to circulate.
• never immerse the motor block in water! Short-circuit danger! Do not put any cloth or
napkins underneath the appliance to avoid endangering by fire and electric shocks.
• never situate the appliance close to a strong heat source or a hot surface (for example:
heater, stove or grill).
• Ensure that the switch and cable do not come into contact with water! Should this inad-
vertently happen, all parts must be completely dry before the appliance is used again.
• never let water or other liquids run into the motor block.
• never clean the power cord or the appliance in the dishwasher, poor liquids over the
appliance or douse or dip it in water or other liquids. In case that water or other liquids ran
into the appliance while operating turn off the appliance immediately, pull the plug and dry
the appliance with a clean cloth (›Care and cleaning‹).
• Do not use the appliance in moist and wet areas.
• Check the power supply cable regularly for wear and damage.
• The mincer must only be connected to a 220-240 V power supply.
• Always disconnect the power supply cable from the mains before assembling, disman-
tling and cleaning the appliance or before exchanging mincing plates.
• Always unwind the power cord completely before installing the appliance.
• Place the appliance close to a power point and connect it directly without using any
extension cords to avoid additional risks of injury through fire or voltage.
• Only install the appliance in proper form secure grounding receptacle with adequate elec-
tric power supply (alternating current; 220-240 V, 50 Hz) and ground fault circuit interrupter.
The maximum power consumption of the appliance is 1,000 Watt. You should also install a
fuse with a release current of maximum 30mA. If necessary ask your electrician for help.
• never pull, rip, bend, clamp, squish or knot the power cord. Pay attention to the power
cord not hanging of the table. Attend to nobody getting caught in loops of the line cord or
pulling the appliance of the work space. When pulling the plug always catch hold of the
enclosure of the plug.
• Carry the appliance with both hands by the motor block – never by the filling pan or the
mincer.
• The mincer must only be used to process meat and vegetables. Do not mince hard parts
such as bones. Do not mince hard-fibre foods such as ginger, etc. Do not let the motor run
longer than necessary to prevent overheating. After turning off the appliance the motor
needs about 6 sec. to stop moving.
• Clean the appliance straight after use and rinse off leftover food. Remove such dirt imme-
diately and operate according to the instructions ›Care and cleaning‹ before storing the
appliance. Do not let food desiccate on the appliance.
21