Gastroback 98100 Pasta Attachment - Manual (Page 4)

Pasta Attachment
Operating
Before first use of the Pasta Attachment
Remove all promotional materials and packing as well as any foreign objects, but do
not remove the model label. Before first use and after a long period of storage, clean
the processing tools in warm soapy water (see ´Care and Cleaning`).
Using the Pasta Attachment
WARNING: Always switch ´Off` the appliance, wait until
the motor stops completely and unplug the appliance
before assembling/disassembling the attachment. To turn
the appliance ´Off` you have to turn the speed control
anticlockwise into the ´Off`-position.
Assemble the Pasta Attachment
1. Take the housing into your left hand. The part with the
thread has to face the front and the feed chute has to
face upwards.
2. Take the scroll into your right hand and place it into the
housing. The axis has to face the housing when sliding the
scroll into the housing (picture A).
NOTE: The scroll is correctly located when the scroll is
pushed up all the way inside the housing and the end of
the axis pokes out of the back end of the housing.
3. Fit the desired pasta screen over the axis of the scroll
inside the housing (picture B). Ensuring that the pasta screen
is correctly located. The side of the screen with the round
hole in the middle must face the scroll, the side with the
number in the middle has to face the ring nut.
IMPORTANT: The pasta screen has two gaps which have
to fit into the corresponding lugs of the housing. If necessary
turn the screen a little bit to make it slide into the right position.
NOTE: The screen will not flush with the rim of the housing
when located in the right position.
4. Take the ring nut and screw it onto the thread of the
housing turning it clockwise (picture C). You can use the
spanner to securely tighten the ring nut (picture D).
15
A
B
C
D
98100_pastaaufsatz_deskuechmaschadv_manual.qxp 11.12.2007 14:44 Seite 15