Gastroback 98101 Meat Grinder / Cookie Attachment - Manual (Page 6)

WARNING: Always make sure that the appliance is turned ´Off` before plugging
in the power supply.
3. Plug the power supply cable into a mains socket.
WARNING: Never hold your face or other body parts over the feed chute when the
motor is running because little pieces of food could be thrown out of the feed chute.
Never push the food into the feed chute with your fingers or put foreign substances
(hair, towels, cutlery) into the feed chute. Always use the food pusher for this purpose!
ATTENTION: Avoid contact the moving parts. Keep hands, hair, clothing,
as well as spatula and other utensils, away from feed chute during
operation to prevent injury and/or damage to the appliance.
4. Switch on the appliance using speed setting 4.
IMPORTANT: Speed setting 4 is the highest speed setting you are allowed to
choose, when using the Meat Grinder Attachment.
5. Slowly feed the meat pieces (a piece at a time) through the feed chute and push down
with the food pusher. Do not apply excessive force when pushing down the food
pusher. Use only the food pusher to press down the meat. Never use the fingers!
IMPORTANT: Operate in a slow and constant pace. Do not try to rush the procedure
by pushing down the meat with force. This way the scroll might gets blocked and
stops operating. If no meat is coming out the outlet even though there is still meat in
the feed chute turn the appliance ´Off` and work according to the instructions ´Trouble
shooting guide`.
6. Switch ´Off` the appliance after use and disconnect the power supply cable
from the mains socket.
7. As soon as the last bit is minced turn the appliance ´Off` and pull the plug.
8. Clean and disassemble the appliance right after use and make sure that no
leftover food desiccate on the appliance. Work according to the instructions ´Care
and cleaning`.
Dissemble the Meat Grinder Attachment
1. Switch ´Off` the appliance after use and disconnect the
power supply cable from the mains socket.
2. Take the tray out of the feed chute.
3. Press down the attachment ejector (picture A) and pull the
Meat Grinder Attachment out off the access opening.
4. Take off the ring nut by turning it anticlockwise. You can use
21
A
98101_fleischwolfaufsatz_deskuechmaschadv_manual.qxp 11.12.2007 15:12 Seite 21