Gastroback 40985 Design Classic Digital Mixer - Manual (Page 9)

damp or wet or is touching wet surfaces while connected to the mains power supply. In this
case, immediately unplug the appliance and dry the appliance (see ›Care and Cleaning‹).
• Ensure that the holder is leak-proof before putting the glass container on the motor block.
Always wipe off spilled liquids immediately. Do not immerse the motor or power cord in any
liquids or spill any liquids on it or place the motor on wet surfaces. Never let any liquids run
into the motor block or underneath it to avoid electric shock. There are louvre underneath
the motor block. Ensure that no water can run into the louvre. When liquids are spilled on
the motor housing, immediately unplug the appliance and dry the motor housing to avoid
risk of electric shock or fire. Do not attempt to operate the appliance, when liquids are on
or in the motor housing.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
Technical Specifications
Modell: Art.-No.: 40985 Design Classic Digital Mixer
Power supply: 220-240 V/ 50 Hz
Power consumption: 750 W
Revolutions: 21,500 per minute
Length of power cord: ca. 90 cm
Weight: ca. 4.2 kg
Dimensions: ca. 200 x 198 x 414 mm (W x D x H)
Maximum filling level glass jug: ca. 1.75 l
Assembling and disassembling the appliance
Disassembling the glass container
1. Always turn the appliance ›OFF‹, wait until the motor stops and unplug the appliance
before assembling/disassembling. Always completely assemble your appliance before you
put the plug into the power outlet.
2.
Take the lid off the glass container and empty the container.
3. Clean the units with a soft sponge in warm soapy water and dry them off afterwards.
WARNING: The blade is very sharp. Pay attention not cutting yourself cleaning the blade.
Do not use abrasive cleaners, cleaning pads, corrosive chemicals (disinfectants, bleach) or
any sharp or hard objects (i.e. metal scouring pads) for cleaning, for this could damage the
surfaces. Always handle the entire appliance with care and without violence.
Assembling the glass container
Ensure that the glass container is clean before you connect the holder and the blade.
1. The blade has a sealing ring. Ensure the sealing ring seals the glass container properly.
Before filling liquid into the container check if the container is leak-proof by filling it with
27