Gastroback 40985 Design Classic Digital Mixer User Manual

Page 14

Cleaning the container

1. Empty the container and rise it with warm water.
2. Replace the container on the motor block.
3. Fill the container with warm soapy water. The water level should be high enough to

cover the blade with water but not too high to avoid run over liquids. Close the lid and turn

on the motor on ›5‹. Let the motor run for a few seconds.
4. Turn the motor ›Off‹, wait for the blade to stop moving and take the container off the

motor block.
5. Pull the plug out of the power outlet.
6. Take the lid off the container and pour out the water. Stubborn residues you can remove

using a nylon washing brush or sponge.

WARNING:

Pay attention not to cut yourself cleaning around the blade or cleaning the

blade.
IMPORTANT: The container should be clean now. For the case that there are stubborn

residues on the container or the blade, soak stubborn residues for a few minutes and then

remove them using a nylon washing brush or sponge. Do not cut yourself.
7.

Clean the lid and the refill lid with soapy water.

Rinse the container, the lid, and the refill lid with clear water and dry the units thoroughly

and carefully with a cloth or leave all parts dry naturally where they are out of reach of

young children. When the units are dry assemble the container for storage or usage.

Cleaning the motor block
WARNING:

Do not place the appliance in an automatic dishwasher or pour boiling

water over it. Do not immerse the motor or power cord in any liquids or spill any liquids on

it or place the motor on wet surfaces. Always wipe off spilled liquids immediately. Ensure

that no water can run into the louvre. When liquids are spilled on the motor housing, imme-

diately unplug the appliance and dry the motor housing to avoid risk of electric shock or

fire. Do not attempt to operate the appliance, when liquids are on or in the motor housing.
1. Always turn the appliance ›OFF‹, wait for the motor to stop completely, and unplug the

appliance from the power outlet before you start cleaning the motor block.
2. Wipe the motor housing and power cord with a damp soft cloth. Take care not to spill

or drip water or any other liquids on the motor housing.
ATTENTION: Ensure not to damage the drive gear. Never poke with anything into the

motor block. If necessary use a soft brush for cleaning. If any liquids run into the motor block

clean and dry the motor block very carefully.
3.

Thoroughly dry the motor housing after each cleaning or leave it dry naturally where it

is out of reach of young children. Afterwards assemble the appliance.
ATTENTION: You do not need to oil the motor. Clean the units only as described in the

instructions.

WARNING:

Return the entire appliance (including all parts and accessories) to an author-

ised service centre for examination and repair.