Gastroback 40119 Design Juicer Basic - Manual (Page 8)

8
Assembling your Design Juicer Basic
Step 1:
Place the filter bowl surround on the motor block
(picture 1).
Step 2:
WARNING: Handle the units with care and do
not use any force. Pay attention to the sharp
blades on the stainless steel micro mesh filter
and the feed chute to avoid injury. Always
completely assemble your juicer before you
plug the plug into the power point.
ATTENTION: Ensure the stainless steel filter
basket is clean before assembling. Any dehumidified
left over food on the basket will block the fine
mesh holes. If necessary remove excess fibre
build up (from fruit or vegetables) according to
the instructions ´Care and Cleaning`.
Align the arrows on the stainless steel filter basket
with the arrows on the motor drive coupling and
push down until it clicks into place. Ensure the
stainless steel filter basket is fitted securely
inside the integrated pulp container and onto
the motor base (picture 2).
Step 3:
Place the juicer cover over the stainless steel filter
on top of the filter bowl surround (picture 3). The
feed chute has to be positioned in the middle of
the filter basket and the pulp spouting of the cover
has to face away from the interlocking safety arm.
1
2
3
!
!
40119_Manual_Englisch.qxp 04.09.2008 10:10 Seite 8