Gastroback 40119 Design Juicer Basic - Manual (Page 10)

10
Assembling your Design Juicer Basic
Operating your Design Juicer Basic
WARNING: Make sure the appliance is
completely assembled and that there are nor
foreign objects in the feed chute before putting
the plug into the power point.
Never put fingers, wooden spoons or other
foreign substances (such as hair, clothing, brushes,
cloth) into the feed chute.
Always turn the appliance off and wait for the
motor to stop moving before removing the lid of
the juicer.
Slide the food pusher all the way down the feed
chute (picture 5a).
Step 6:
Place the pulp container into position by tilting
the motor base slightly to the right. Insert the
container under the juicer cover on the left-hand
side ensuring it is supported by the container
support extending from under the motor base
(picture 6).
NOTE: To minimise cleaning, line the pulp container
with a plastic freezer bag to collect the pulp. Pulp can
then be used in other dishes, or as compost for the
garden or discarded.
Step 7:
Fit the custom-designed juice nozzle over the juice
spout and place a glass underneath. The juice
nozzle will prevent splatter, ensuring mess free
juicing (picture 7).
5a
6
Keep the working place clean and dry. Do not
let any liquids or water run into the motor block.
Do not put any cloth or napkins underneath
the appliance to avoid endangering by fire and
voltage. In case that water or other liquids ran
into the motor block while operating turn off the
appliance immediately, pull the plug and dry
the appliance with a clean cloth. Operate
according to the instructions ´Trouble shooting
guide`.
7
40119_Manual_Englisch.qxp 04.09.2008 10:10 Seite 10