Care and cleaning – Gastroback 42320 Easy Cino Plus Milk Frother User Manual

Page 11

attention:

Use liquid food for frothing only and only add powder for flavouring. Solid

food can damage the milk frothing spiral and the motor and therefore are not permitted

for use.

Care anD Cleaning

After each use it is important that you properly clean the appliance. You should rinse the

pitcher in cold water prior to frothing.
imPortant:

Careless handling can cause water to permeate the bottom of the pitcher and

causes damage to the electronic components and risk of fire, electric shock and overheating. Never

immerse the pitcher in water to avoid damages. Attend to following details:
imPortant: Do not immerse the pitcher, power base or power cord in water or any other

liquid.
ATTENTION: The pitcher, lid, milk frothing spiral, milk stirrer and power base

are not dishwasher safe.

Care of the Power Base

• Always unplug the power base before cleaning.
• Never immerse power base or cord in water. Clean the power base with a warm damp cloth

or sponge and dry with a soft towel. Do not let any liquid run into the power base.
warning: Risk of fire and electrical shock. Never open the power base for cleaning.

Care of the attachments (milk frothing spiral and milk stirrer)

Take the attachment off the shaft and carefully wash with warm soapy water using a sponge

or scrubber pad. Rinse with water and dry with a soft towel.
note: In case of grease residues on the milk frothing spiral the frothing process is mal-

functioning because the grease of the fresh milk can not get filtered out.

Care of the Pitcher

• Never immerse the pitcher in water.
• The pitcher should never be placed in an automatic dishwasher! This would cause damage

to the electronic components in the bottom of the pitcher.

• Immediately after each use place a small amount of warm water in the pitcher to soak. The

water helps prevent the build up of ingredients on the non-stick coated surface and makes

cleaning easier.
• Carefully wash the pitcher and lid with warm soapy water using a sponge or cloth that is

suitable for cleaning non-stick coating. Rinse with cold water and dry with a soft towel.
• Remove fluid contamination or dirt on the buttom of the pitcher with a clean close. Do not

damage or allow water running into the electric contact.