Gastroback 42320 Easy Cino Plus Milk Frother User Manual

Page 10

imPortant: There are two max level indicators inside the pitcher.

The lower level max level indicator is for frothing milk and the upper

max level indicator for heating milk (picture C). You need less milk

for frothing because the volume of milk froth is bigger then the volume

of heated milk. Using too much milk when frothing would cause over-

running.
imPortant: never

overfill the pitcher. Spilling liquids can cause

damage to the electronic components.
note:

The volume, texture, and taste of froth vary depending on the fat content and amount

of milk and flavouring used. The milk frother produces the greatest volume of rich, thick, froth

using cold, fat free milk. 0,3%,1,5%, 3,5% and whole milk froth well, but due to a higher fat

content they produce a froth with a slightly different texture and less volume but sweeter. To

prepare toppings for coffee or dessert, using the maximum amount of milk will produce approxi-

mately 3-4 servings generous servings.
note: To make flavoured froth, frothy drinks, dessert toppings or desserts, you may add

syrups, powders, sugar, sugar substitutes or liqueurs to the milk. See milk froth recipes in the

back of the manual instructions.
5. Place the lid on the pitcher and ensure the pitcher is closed properly.
6. Place the pitcher onto the power base. The electric contacts of the

multi-directional power base will slide into a corresponding opening in the

bottom of the pitcher. The power base will work out in any orientation

(picture D). Press the start button on the pitcher. The start button will illumi-

nate blue when the appliance is switched on.
note: if the attachment does not start to rotate as soon as the

appliance is switched on carefully activate the attachment using

a finger. Be careful not to burn yourself touching the hot bot-

tom of the pitcher.
7. Once the heating and frothing or whipping cycle is complete, the appliance will shut off

automatically.
note: The heating and frothing or whipping cycle can be stopped at anytime by simply lifting

the pitcher off the power base.
8. When making froth (using the milk frothing spiral) allow 1 minute for the hot milk to settle

after the cycle is complete. Take the lid of the pitcher and pour desired amount of hot milk for

Cappuccinos, Lattes or other Specialty Drinks. Take a spoon to hold back the froth when pouring

the milk.
note:

Remember that the liquid milk heats to a higher temperature than the froth. If serving

to children, wait until hot milk cools slightly or stop the frothing & heating cycle earlier by lifting

pitcher off the power base.
9. Spoon out the exceptionally rich froth. If desired, the pitcher can be removed from the

power base and used for serving. If you want the milk froth or hot milk pour out, please ensure

that the attachments will be hold back. They may fall out, because it is loose on the clutch.
10. After use, clean your appliance following the ´Care & Cleaning` instructions. Remember to

rinse in cold water before each use.