Gastroback 42325 Latte Magic - Manual (Page 8)

30
Moving parts
The milk frothing disc of the appliance is driven electrically via a magnet. Thus, you should
always avoid inserting your hands, or any delicate objects in the jug, when the jug is placed
on the power base and the appliance is connected to the power supply.
tecHnIcaL specIfIcatIOns
Model: Art.-Nr. 42325 Latte Magic / 42326 Latte Magic
Power supply: 220 – 240 V AC, 50 – 60 Hz
Power consumption: 420 – 500 W
Revolutions: 2,500 – 3,000 per minute
Length of power cord: ca. 75 cm
Weight (with lid): ca. 0.88 kg
Dimensions: ca. 15.5 cm x 12.0 cm x 20.0 cm (width x depth x height)
Capacity: 0.5 Litre
Compliance:
prOpertIes Of yOur new MILk frOtHer
Your new Milk Frother has been designed specifically for the purpose of foaming milk and
milk alternatives.
IMpOrtant: The appliance is not intended to thicken or heat other food substances (e.g.
custards, soups, gravies), or to whip cream or egg white. Additionally, the appliance is not in-
tended to mix a large quantity of dry and/or solid ingredients (e.g. ground nuts, spices, flour,
cacao powder, herbs) or melt large pieces of food (e.g. chocolate or butter).
The frothing disc is driven contact-less via magnets. No opening for a drive shaft is necessary
in the jug, thus avoiding weak points and leaks. As a result, cleaning is made much easier,
too. Due to the seal at the brim of the lid, the contents will not drip or splash out of the jug,
when operated correctly.
safety concept
For your protection and convenience, your new milk frother offers an innovative design.
• After being used the milk fFrother will switch off automatically and the illuminated button
turns off.
• Overheat protection: The Milk Frother will automatically cease to operate, if the jug
overheats. Wait 30 seconds before turning the appliance back on.
• The appliance operates via an magnetic drive system. Thus, injuries are avoided as far as
possible, because you cannot unintentionally touch any heated or moving parts in the power
base. Just keep in mind that the jug is heated and thus, everything touched by the hot jug will
get hot, too. Therefore, after operation and removing the jug, let the power base cool down
for some minutes, before moving or cleaning.