Gastroback 42325 Latte Magic - Manual (Page 12)

34
frothing warm Milk
A. Press once for 1 second on the start button.
B. The button lights up red. The appliance starts to heat the milk and froth.
C. The foaming process is completed when the button is no longer illuminated.
Capacities:
100 ml milk (MIN mark) result in about 300 ml of milk foam.
150 ml milk (MAX mark FROTH) result in about 350 ml of milk foam
frothing cold Milk
A. Press once for 3 seconds the start button.
B. The switch lights up blue. The appliance begins to foam the milk without heating.
C. The foaming process is completed when the button is no longer illuminated.
Capacities:
100 ml milk (MIN mark) result in about 150 ml of milk foam.
150 ml milk (MAX mark FROTH) result in about 280 ml of milk foam
Heating milk
A. Press quickly twice on the start button.
B. The switch flashes red. The appliance starts to heat the milk.
C. The heating process is completed when the buttonswitch is no longer illuminated.
Capacities:
maximum of 250 ml of milk (MILK MAX mark)
minimum of 100 ml of milk (MIN mark)
8.
Once the heating and frothing or whipping cycle is complete, the appliance will shut off
automatically. The button is not illuminated any more.
note: The heating and frothing cycle can be stopped at anytime by simply lifting the jug off
the power base or by pressing the start button twice.
9.
After frothing allow 1 minute for the hot milk to settle after the cycle is complete. Take the
lid of the jug and pour desired amount of hot milk for Cappuccinos, Lattes or other Specialty
Drinks. Take a spoon to hold back the froth when pouring the milk.
note: Remember that the liquid milk heats to a higher temperature than the froth. If serving to
children, wait until hot milk cools slightly or stop the frothing & heating cycle earlier by lifting
jug off the power base.
10.
Spoon out the exceptionally rich froth. If desired, the jug can be removed from the power
base and used for serving. If you want the milk froth or hot milk pour out, please ensure that
the attachments will be hold back. They may fall out, because it is loose on the clutch.
11.
After processing the milk froth, unplug the appliance from the power outlet.
12. After each use, clean your appliance following the ›Care & Cleaning‹ instructions. Remem-
ber to rinse in cold water before each use. Do not let any food dry onto the appliance.
attentIOn: Use liquid food for frothing only and only add powder for flavouring. Solid food
can damage the milk frothing spiral and the motor and therefore are not permitted for use.