Archived 4/2/10 – ETS-Lindgren HI-4456 Isotropic Electric Field Probe (Archived) User Manual
Page 10

HI
n
4456 Manual
Page — 5
3.0 ACCEPTANCE AND CONTROLS
Introduction
This section contains information on: unpacking and
acceptance of the HI
n
4456; probe controls; probe
connectors; the battery, and the battery charger.
Unpacking and Acceptance
Step 1.
Upon delivery of your order, inspect the
shipping container(s) for evidence of damage.
Record any damage on the delivery receipt
before signing. In case of concealed damage
or loss, retain the packing materials for
inspection by the carrier.
Step 2.
Remove the probe from its shipping
containers. Save the boxes and any protective
packing materials for future use.
Step 3.
Check all materials against the packing list to
verify that the equipment received matches
that which was ordered. If you find any
discrepancies, note them and call Holaday
Customer Service for further instructions.
Be sure that you are satisfied with the contents of your
order and the condition of your equipment before
installing the probe.
Probe
A switch, two fiber optic connectors and a battery
charger connector are mounted on the HI
n
4456
electronics housing (Figure 3
n
1).
XMIT/RCV
The fiber optic cable assembly from the
receiver is attached to the probe via two
Archived 4/2/10