Archived 4/2/10, 0 specifications – ETS-Lindgren FP2083 Isotropic Electric Field Probes (Archived) User Manual
Page 47
Isotropic Electric Field Probes
HI-4453/FP5083/FP4083/FP2083
© ETS-LINDGREN L.P. – June 2005
Rev. F, P# H-600064
47
4.0 Specifications
POWER
Main:
IEC filtered AC power input module
110 - 240 Vac, 500 mA MAX., 50 - 100 Hz
Alternate:
Automobile cigarette lighter to 2mm power plug
adapter cord., 12.5 Vdc, 100 mA
Fuses: 250 Volt, 1.0 Amp, Type T (5 mm x 20 mm)
OUTPUT
Open
Circuit
Voltage:
15
Vdc
Fast Charge Pending Current:
60 mA
Fast
Charge
Current:
1400
mA
Pulsed Trickle Charge Current:
50 mA
Output Voltage (During Fast Charge):
3 - 6 Vdc
NICD BATTERY:
3.6 Volt 3 Cell NiCd Battery, 1400 mAH (Rapid charge cells, 1.2
volts/cell); ETS-Lindgren Part #491038
ENVIRONMENTAL
Operating temperature 10 to 40
{
C
Humidity:
5% to 95% relative humidity,
non-condensing
POWER CABLE
This charger is shipped with a three-wire power cable. When
this cable is connected to an appropriate AC power source, it
connects the chassis to earth ground. The type of power cable
shipped with each battery charger depends on the country of
destination.
Archived 4/2/10