ETS-Lindgren 2188 Turntable - Manual (Page 14)

Model 2188 Turntable
©ETS-Lindgren—January, 2006
Rev. B—P#399771
14
3.2. Unpacking
A qualified installer will perform the following steps in preparation for
installation of the turntable. Please pull the drawings from the back pocket
of this manual to assist in the installation directions that follow.
1. Uncrate all parts. Check all parts for any shipping damage. Ensure
a clear area is available to assemble the turntable unit safely.
NOTE: Do not discard any packing material or parts until the
turntable is fully assembled.
2. Verify that that fiber optic cable is long enough to reach from the
turntable to the control room. When working around the table,
avoid stepping on the fiber optic connectors located on the motor
base.
3. If the turntable is to be installed in a pit, check pit depth and inside
diameter and compare measurements with the drawings for your
turntable size at the back of this manual. The inner diameter of the
receptacle pit should be as follows:
• 1.2 meter turntable = 49.00” (+/-0.25”)
• 1.5 meter turntable = 60.00” (+/-0.25”)
• 2.0 meter turntable = 79.75” (+/-0.25”)
4. Remove the bolts that attach the top onto the turntable drive
assembly. These are the six flathead bolts closest to center of the
tabletop. Remove top and place in position as not to damage any
components on the top. Refer to the assembly drawing 2188-1.2,
2188-1.5 or 2188-2.0 included at the rear of this manual for more
details.
3.3. Positioning the Turntable
5. Using a forklift or other appropriate lifting device, place the turntable
bottom into position. The motorbase with the fiber optic connectors
should point in the direction that the fiber optic cable will be
installed. This position will reduce the chance of the cable being
kinked or twisted.