ETS-Lindgren 2188 Turntable - Manual (Page 13)

Model 2188 Turntable
©ETS-Lindgren—January, 2006
Rev. B—P#399771
13
3. Installation
The turntable installation will vary based on the host location. Several
installation options may be presented in the steps that follow. Please
select the option that applies to your location.
The installation of turntables must be performed by a factory installation
specialist or by individuals who have been authorized by ETS-Lindgren to
do such work. Proper installation of the turntable directly affects
performance. The following installation information is provided to
familiarize the user of the turntable with the installation process.
CAUTION: Ensure power is off and secured before proceeding further.
3.1. Tools Required
•
3/16
” Allen wrench
• ¼” Allen wrench
•
3/8 ” Allen wrenches, qty 3
• 6 mm Allen wrench
•
3/8
” ratchet wrench
• 12” crescent wrench
• 15 mm, 12 point socket for
½” square head screws
•
7/16
” open/box end wrench
• ½” open/box end wrench
• ¾” open/box end wrench
• 0.120 drill bit for 6-32 self
tapping screws
• #7 Drill bit for ¼-20 tap
•
3/8 ” hand drill
•
9/32 drill bit
• #2 Phillips screw bit
• #3 Phillips screw bit
• Measuring tape
• Pry bar
• Level
• Square
• Hacksaw
• Black marker
• File
• WD 40
• ¾” pipe clamp ends
• ¾” pipe (length depends on table
size 6 ft. will cover most tables)
• 1 – ½” C-clamps, qty 8
• Cutting Oil
• Syringe for applying conductive
grease
• Grease Gun
• Vacuum
• ½” Hammer Drill
CAUTION: Only qualified personnel must perform lifting of the
turntable assembly using a forklift or other lifting machinery.
Damage to the turntable or serious injury to the personnel may
occur.