EFCO 5XP Series - Manual (Page 10)

EFCO CORPORATION 6/8/2012 PART NO. YW43 Page 10 of 34
5XP SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
3. Shim as required to allow for the proper engagement of the sliding glass door head into the
subhead. (See Fig. C)
4. Backbed the Sliding Glass Door to subhead contact area with silicone sealant before
installing the door or cap seal after the door is installed. (See Fig. D)
Seal over the anchor bolt heads.
The subhead is now ready to install the Sliding Glass Door frame.
(See the assembly instructions (SECTION III) for assembly of the Sliding Glass Door frame)
Fig. D
Shim
Fig. C
Silicone backbed or cap seal
after the door is installed.