EFCO Sliding Glass Door - Manual (Page 47)

EFCO CORPORATION 6/8/2012 PART NO. YW41 Page 47 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
Installing the Threshold: The threshold is shipped long with a notch in both ends for field fit. One of the
notched ends is to fit into the jamb recess, and the other end is to be square cut and fitted against the fixed
panel meeting rail. Locate 3179 threshold. Cut to length between the jamb and the meeting rail. Push
down over the clips that are fastened to the sill.
Fixed panel should be sealed in doorframe before loading the operable panel and attaching head filler and
threshold.
Locate 11F9 head filler. Cut to length between the jamb and meeting rail. Push into the exterior track at
the head.
Locate and install the operable panel onto the sill track. Position the operable panel to one side of the
door. Locate 3150 head closure and install up into the head. Through existing holes in the head closure,
fasten STK5 tek screws (#10-16 x 3/4” PL-PH-SMS 410 tek). Move the operable panel to the other side of
the door and finish installing STK5 screws in the head.
Fixed Panel
Square Cut
End
Notched End
3179
Threshold