EFCO Sliding Glass Door - Manual (Page 26)

EFCO CORPORATION 6/8/2012 PART NO. YW41 Page 26 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
Locate 3246 and 3188 jambs.
Adhere H076 head gaskets and H031 sill gaskets to the jambs (S-3001).
Adhere H075 head gaskets and H098 sill gaskets to the jambs (S-3000 modified).
Gaskets have a pressure sensitive adhesive on one side of the gasket. Match up the holes in the gasket
with the holes in the jambs and adhere to the jamb.
Locate the head and sill. Fasten the head and sill to the jambs with SLQ6 screws (#8 x 1 ¼” PL-PH-SMS
410 B-LP MG).
For proper door operation, position the doorframe in the opening by using shims as needed to ensure that
the frame is plumb, square, and level without warp, twist, or bow.
Head
Jamb
Jamb
Sill
EW65
Threshold
3390
3492
H031 Gasket (S-3001)
H098 Gasket (S-3000 Modified)
(adhere to the jamb)
H076 Gasket (S-3001)
H075 Gasket (S-3000 Modified)
(adhere to the jamb)
Interior
Exterior
Setting Channel
F132
Lay the setting channels F132 in the
outside sill track at approximate quarter
points of the fixed panel.