EFCO Sliding Glass Door - Manual (Page 27)

EFCO CORPORATION 6/8/2012 PART NO. YW41 Page 27 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
Locate the fixed panel and install the fixed panel into the doorframe on the operable jamb side of the door.
Locate 3492 head closure and install into the head. Through existing holes in the head closure, fasten
STK5 tek screws (#10-16 x ¾” PL-PH 410 tek). Move the fixed panel into the fixed jamb and finish
installing the STK5 tek screws in the head.
Before fixed panel is installed, verify that
HN06 blocks are in place. This allows the
interlocks not to interfere with one another
after final assembly.
Silicone in Place HN06
(1/8”x 1”x 4”) Setting Block
Before installation of the
fixed panel, run a bead of
silicone at this
intersection, on both
jambs. Do this at the
head and sill.
STK5
3492 Head
Closure
SFP1
HN06
Fixed Panel
Setting Channel
F132