EFCO Sliding Glass Door User Manual

Page 35

EFCO CORPORATION 6/8/2012 PART NO. YW41

Page 35 of 59

SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS

Before installation of the fixed panel, run
a bead of silicone at this intersection, on
both jambs. Do this at the head and sill.

STK5

3151 Head
Closure

SFP1

Fixed Panel

Locate the fixed panel and install the fixed panel
into the doorframe on the operable jamb side of
the door. Locate 3151 head closure and install
into the head. Through existing holes in the
head closure, fasten STK5 tek screws (#10-16 x
¾” PL-PH 410 tek). Move the fixed panel into
the fixed jamb and finish installing the STK5 tek
screws in the head.

There will be two countersunk holes located at
the interior side of the head, where the meeting
rail of the fixed panel tucks into the head. After
obtaining the 1 1/16” dimension (shown on the
following page) at the jamb, match drill through
the two countersunk holes with a 5/32” drill bit.
Fasten SFP1 screws (#10-15 x 1” PL-FH-SMS
18-8) through the two countersunk holes.