EFCO E-Lite User Manual
Page 7

EFCO CORPORATION 6/2012 PART NO. YWLS
Page 7 of 19
E-Lite Fabrication, Assembly and Installation Instructions
Section IV: E–Lite “Stick Built” Aluminum Panel Installation
1. Sizing the 1/8” aluminum sheet (sheared to make size dimensions).
A.) The make size dimensions for the 1/8” aluminum sheet are not to exceed 36” X 120”. The make sizes can be
easily calculated by adding up the centerline to centerline dimensions of the support struts in long runs, and
subtracting .125 at the intermediate panel locations, and adding .562 at the end panel locations. It is also
recommended that a .125 gap be left between the aluminum panels at increments not to exceed 120” of panel
length. The .125 gaps MUST OCCUR at the support strut locations.
2. Loading the Aluminum Sheet Panels.
A.) The top aluminum sheet panel can be slid into place with the nonspecular reflective finish facing up. Take
care to square the panels and the struts. DO NOT FASTEN the panel to the struts.
Support Strut
Support Channel
Aluminum Sheet Panels
- Windows Hung General Maintenance Instructions (19 pages)
- Windows Hung Understanding Condensation (6 pages)
- Windows Hung Installation (58 pages)
- E-Shade (41 pages)
- 2 1/2" Center Tongue Sun Shade Clip (19 pages)
- S5500 Advanced (46 pages)
- S5500 Inside Glazed (48 pages)
- S5500 Outside Glazed (48 pages)
- S5500 Router & Jig (6 pages)
- S5500 SSG Captured (81 pages)
- S5500 SSG (53 pages)
- S5600 Concealed Vent (13 pages)
- S5600 Inside Glazed (29 pages)
- S5600 Outside Glazed (26 pages)
- S5600 Slope Glazed (23 pages)
- S5600 Structural Glazed (28 pages)
- S5900 Inside Glazed (18 pages)
- S5900 Outside Glazed (16 pages)
- S5900 Structural Glazed (23 pages)
- 5500X Outside Glazed (60 pages)
- Duracast Pressure Plate (12 pages)
- 5800 Series (20 pages)
- 8700 Series Assembly Instructions Vol.1 (35 pages)
- 8700 Series Assembly Instructions Vol.2 (34 pages)
- 8700 Series Assembly Instructions Vol.3 (28 pages)
- 8700 Series Assembly Instructions Vol.4 (44 pages)
- 8700 Series Assembly Instructions Vol.5 (89 pages)
- 8700 Series Assembly Instructions Vol.6 (16 pages)
- 8700 Installation Instructions (68 pages)
- 8750XD (43 pages)
- 875X Wall Vent (31 pages)
- 401 Series Roto Vent for Storefront (14 pages)
- 401 Series Storefront (94 pages)
- 406 (T) Series (41 pages)
- 433 Series (90 pages)
- 525 Series (45 pages)
- 526 Series (50 pages)
- 960 Series (65 pages)
- WV410 (21 pages)
- 403X Series (29 pages)
- 406X Series (25 pages)
- 945 Series (50 pages)
- 955 Series (45 pages)
- 901 Series (52 pages)