Removing the standard air brake system – Dynojet Proportional Air Brake User Manual
Page 7
I N S T A L L A T I O N G U I D E
Installation
Version 4
Proportional Air Brake Installation Guide
3
R
EMOVING
THE
S
TANDARD
A
IR
B
RAKE
S
YSTEM
1
Turn off the power on the dyno electronics.
2
Shut off and release the air pressure to the air pressure regulator.
3
Remove the two black wires from the wiring block labeled BRAKE on the
Breakout board.
4
Remove the yellow and black wires from the wiring block labeled PRESS on the
Breakout board.
5
Disconnect the 3/8-inch air hose from the fitting on the air brake control switch.
The air brake control switch is located on top of the right side air canister.
Note: Leave the air hose with the dyno as it will be used later.
6
Unscrew and remove the air brake control switch.
Figure 2: Remove the Standard Air Brake
brake
press
air hose
air brake
control switch