Dynojet Proportional Air Brake - Manual (Page 14)

Proportional Air Brake Installation Guide
P R O P O R T I O N A L A I R B R A K E
Wiring—Four Wheel Drive
10
W IRING THE B REAKOUT B OARD
1 Attach the cable coming from the EPR to the Breakout board. The EPR cable wires
connect to the wiring block labeled LOAD CONTROL.
2 The Breakout board jumper settings are preset, however, verify jumpers J1 and J2
are set for the four wheel drive proportional air brake as shown in Figure 9.
Figure 9: Four Wheel Drive—Wiring the Breakout Board
• Blue wire connects to V- • Orange wire connects to V+
• White wire connects to O+ • Green wire connects to O-
load control
jumpers
J1 and J2
four wheel drive
prop air brake
jumper settings