Dynojet 224: Eddy Current Brake - Manual (Page 10)

Model 224 Above Ground Eddy Current Brake Installation and User Guide
C H A P T E R 1
Power Requirements and Installation
1-6
T ESTING FOR C ORRECT V OLTAGES
You must test the receptacle for proper voltages before the eddy current brake is
connected to the outlet.
If the voltage readings do not match the following table, DO NOT connect the
brake. You must have a licensed electrician correct the power connection.
Connecting the brake to the incorrect voltage can result in damage to the brake
and will void the brake warranty. Contact Dynojet with any questions.
Using a voltmeter that is capable of measuring AC voltage, measure between the
points listed below and verify that the correct voltages are present.
Figure 1-1: Dedicated Power Receptacle
probe 1 probe 2 desired voltage measurement
2 4 216V to 260V*
1 4 108V to 130V
1 2 108V to 130V
1 3 <5V
3 box <5V
*If using two of the three phase lines of a 120/208 V 3 phase Y system,
then expect to see 187V to 225V.
4
1
2
3