Dynojet 250i: Motorcycle Exhaust Extraction System Drawings - Manual (Page 9)

1
1/4
ITEM NO. QTY. PART NO. DESCRIPTION
1 1 InnerHingeFlange MC Exhaust Extraction
2 1 exhvo Outer Verticle Tube
3 1 exhclmpbss Tube Clamp Boss
3
After welding
Drill and tap
3/8-16UNC thru
2
1/4
NOT RELEASED
DESIGNED:
APPROVED:
CREATED:
UNLESS OTHERWISE SPECIFIED:
TOLERANCES
DECIMAL
X.XX ± 0.01
X.XXX ± 0.005 FRACTIONAL
± 1/16
ANGULAR
± 5°
DO NOT SCALE THIS DRAWING
DYNOJET RESEARCH, INC. 200 ARDEN DRIVE, BELGRADE MT 59714
Vertical Outside Tube/Hinge Flange/Boss
Assembly
SCALE: RELEASE DATE: SHEET OF
REV PART NO. SIZE
A
flangetube
ALL IDEAS, DESIGNS, ARRANGEMENTS AND PLANS INDICATED OR REPRESENTED BY THIS DRAWING ARE OWNED BY
DYNOJET RESEARCH INC. AND WERE CREATED, EVOLVED AND DEVELOPED FOR USE ON AND IN CONNECTION WITH
THE SPECIFIED PROJECT. NONE SUCH IDEAS, DESIGNS, ARRANGEMENTS OR PLANS SHALL BE USED BY OR DISCLOSED
TO ANY PERSON, FIRM, OR CORPORATION FOR ANY PURPOSE WHATSOEVER WITHOUT THE
DYNOJET RESEARCH, INC.
NOTES, UNLESS OTHERWISE SPECIFIED
ALL DIMENSIONS ARE IN DECIMAL INCHES.
REMOVE ALL BURRS & SHARP EDGES.
REMOVE ALL TOOLING MARKS.
DIMENSIONS & TOLERANCES SHALL BE HELD
AFTER PLATING OR FINISH. 1.
2.
3.
4. APPROVED DATE ECR# REV DESCRIPTION
REVISIONS
WRITTEN PERMISSION OF DYNOJET RESEARCH, INC.. 1 1 1:8
KAN 06/25/01
LAST UPDATE: XXX xx/xx/xx
MATERIAL:
FINISH:
KAN
Aluminum
None
A
UNRELEASED!
FOR QUOTING OR
PROTOTYPE ONLY