Dynojet 250i: Motorcycle Exhaust Extraction System Drawings - Manual (Page 8)

Align cut tangent to edge of clamp boss in assembly.
.625
DATA FILE PROVIDED TO THE VENDOR. DIMENSIONS
DESIGNED:
APPROVED:
CREATED:
UNLESS OTHERWISE SPECIFIED:
TOLERANCES
DECIMAL
X.XX ± 0.01
X.XXX ± 0.005 FRACTIONAL
± 1/16
ANGULAR
± 5°
DO NOT SCALE THIS DRAWING
DYNOJET RESEARCH, INC. 200 ARDEN DRIVE, BELGRADE MT 59714
Outside Slide Bushing.
SCALE: RELEASE DATE: SHEET OF
REV PART NO. SIZE
A
exhosldbshg
ALL IDEAS, DESIGNS, ARRANGEMENTS AND PLANS INDICATED OR REPRESENTED BY THIS DRAWING ARE OWNED BY
DYNOJET RESEARCH INC. AND WERE CREATED, EVOLVED AND DEVELOPED FOR USE ON AND IN CONNECTION WITH
THE SPECIFIED PROJECT. NONE SUCH IDEAS, DESIGNS, ARRANGEMENTS OR PLANS SHALL BE USED BY OR DISCLOSED
TO ANY PERSON, FIRM, OR CORPORATION FOR ANY PURPOSE WHATSOEVER WITHOUT THE
DYNOJET RESEARCH, INC.
NOTES, UNLESS OTHERWISE SPECIFIED
ALL DIMENSIONS ARE IN DECIMAL INCHES.
REMOVE ALL BURRS & SHARP EDGES.
REMOVE ALL TOOLING MARKS.
DIMENSIONS & TOLERANCES SHALL BE HELD
AFTER PLATING OR FINISH. 1.
2.
3.
4. APPROVED DATE ECR# REV DESCRIPTION
REVISIONS
WRITTEN PERMISSION OF DYNOJET RESEARCH, INC.. 1 1 1:4
KAN 06/15/01
LAST UPDATE: XXX xx/xx/xx
MATERIAL:
FINISH:
KAN
Nylatron.
None
A
SHOWN ARE FOR REFERENCE, ANY OTHER DIMENSIONS
NOT RELEASED
SHOULD BE OBTAINED FROM THE MODEL.
THIS PART IS PRODUCED FROM AN ELECTRONIC
UNRELEASED!
FOR QUOTING OR
PROTOTYPE ONLY
Attatch to outer tube assemblies coincident with clamp
boss end using 4 equally spaced #6x3/8 pan-head
sheet metal screws from the outside.
8.000
7.150