Code 3 vLink - Manual (Page 11)

11
Connections
Wiring varies according to which model variant of
vLink you are installing. In all cases, +12VDC power
and system ground connections must be routed to the
location where the vLink controller will be mounted.
Using the supplied Power Cable assembly, connect
the red wire to a +12VDC Ignition Power source
that is fused at 1A. It’s important that the vLink be
powered from an Ignition switch power source so that
a Power On Reset occurs each time the vehicle is
started. Connect the black wire to vehicle ground at a
point that offers a low resistance path to the battery’s
negative terminal.
Route the control cable from the vLink Controller to
the RLS Siren and connect per the User Manual. The
RLS installation will require the use of the RLSEXP
Modular Expansion Unit and a T11940 Modular
Cable. Route the T11940 cable from the vLink to the
PC Port on the RLSEXP. Connect the RLSEXP to the
RLS Siren using the cables provided with the kit.
When all connections are made, turn on the vehicle’s
ignition and continue on page 18.
RLS SIREN APPLICATION (cont.)
Typical Wiring for vLink-RLS
vLink
TM
Coax Antenna Cable Connection
Ignition Switched +12VDC (fused @
1A)
Ground
RLS Siren Connection
(RLSEXP PC Port)*
*RLS Modular Expansion Unit and T11940 cable required.