Code 3 Torus 3-Up & 6-Up User Manual

Page 5

Setting Parent / Child Mode

All units shipped will be in the PARENT mode with the factory default,

Cycleflash pattern. To change a head to the CHILD mode hold the

White wire to Ground for 5 seconds or more. When in the CHILD mode

the head will need the Grey communications wire connected the PAR-

ENT Grey wire to enable flashing, unless in Steady Burn. Alternatively,

the Grey communications wire of a CHILD can be connected to +12V

to enable flashing during set-up. If communications is lost between the

PARENT/CHILD for over 15 seconds the CHILD head will independently

flash until the communications is restored. A head set to the CHILD mode

can be reset to a PARENT again by holding the White wire to Ground for

5 seconds or longer.

Setting Flash Patterns

To change the flash pattern of any PARENT or CHILD hold the White

wire to Ground for at least 1 second, and less than 3 seconds, and then

release. While holding the White wire to Ground the head will stop flash-

ing until released. Remember that the Grey wire of a CHILD must be

connected to the Grey wire of a PARENT, or to +12V, to enable flashing.

When setting flash patterns, the CHILD will require selecting between Alternating

or Simultaneous patterns, while the PARENT will only require selecting the pat-

tern desired. The tables below show the available flash options and their selec-

tion order for each mode. Simultaneous and Alternating flash patterns are exactly

the same flash patterns but will either alternate or flash simultaneously when

connected to a PARENT. Heads will come from the factory preset to the PARENT

mode with the default Cycleflash pattern. When changing a factory preset PAR-

ENT head to a CHILD the head will default to the Alternating Cycleflash pattern,

position 1, as shown in the table below:

Flash Pattern Description

Alternating Cycleflash ( Factory default)

Alternating Quadflash

Alternating Doubleflash

Alternating Singleflash

Simultaneous Cycleflash

Simultaneous Quadflash

Simultaneous Doubleflash

Simultaneous Singleflash

Steady Burn

3-LED Flash Options Available in PARENT Mode

Flash Pattern Description

Cycleflash (Factory default)

Quadflash

Doubleflash

Singleflash

Steady Burn

Note: When using the Cycleflash pattern, all heads must be in Cycleflash.

All flash pat-

terns are 70 fpm.