Tricore takedown flash pattern, Selecting flash patterns, Step 1 – Code 3 SuperVisor with TriCore for Ford Crown Victoria User Manual
Page 6: Step 2, Step 3, Flash patterns
6
GREEN (PATTERN SELECT)
WHITE (DIMMING)
RED (POWER)
YELLOW (TAKEDOWN STEADY)
ORANGE (TAKEDOWN FLASH)
BLUE (LEVEL 1)
BLACK (GND)
NOTE: FOR SUPERVISORS WITH TAKE DOWN OPTION CONTROL WIRES ARE AS SHOWN BELOW
THE TAKEDOWN STEADY(YELLOW) WIRE WILL OVERRIDE THE TAKEDOWN FLASH (ORANGE) WIRE.
TriCore Takedown Flash Pattern
Selecting Flash Patterns:
The Takedown Lights can be programmed to flash at different rates.
STEP 1:
Power-up the lightbar. Select the Takedown Flash Mode (ORANGE) by applying +power. Programming will not work if
more than one function is selected at a time.
STEP 2:
Observe the flash pattern and determine which pattern is in operation (see Takedown Flash Patterns). This table shows
the available flash patterns. Once the flash pattern has been determined, proceed to Step 3.
NOTE: The default flash pattern for Takedown Lights is Medium Single 115FPM.
STEP 3:
Scroll to the next pattern by momentarily holding the GREEN wire to +power for ~one (1) second. The lightbar will stop
flashing when the wire is connected to +power. Release the wire and the next pattern as listed in Table 5 will begin to flash. The new
pattern is automatically stored each time.
NOTE: To restore the Factory Default Takedown Flash Patterns, hold the gREEN wire to +power for ~four (4) seconds.
wiring Diagram and Flash Pattern Changes - wITH TAKEDOwNS
Flash Patterns
STANDARD LIgHT HEAD FLASH PATTERNS
PATTERN NO PATTERN DESCRIPTION
1
FAST ALTERNATING QUAD FLASH 100ms/25ms
2
PICKET FENCE SINGLE FLASH 200ms/25ms
3
ALTERNATING SINGLE FLASH 200ms/25ms
4
PICKET FENCE QUAD FLASH 100ms/25ms
5
PICKET FENCE SIX FLASH 75ms/25ms
6
SLOW ALTERNATING QUAD FLASH 150ms/50ms
7
SLOW ALTERNATING SIX FLASH 125ms/25ms
8
FAST ALTERNATING SIX FLASH 75ms/25ms
9
VARIABLE RATE PICKET FENCE, SINGLE FLASH
10
ALTERNATING QUAD FLASH, 80 FPM, NFPA COMPLIANT
11
CYCLE FLASH
12
SIMULTANEOUS QUAD FLASH, 75 FPM, NFPA COMPLIANT
TAKEDOwN FLASH PATTERNS
PATTERN NUMBER
PATTERN DESCRIPTION
1
FAST QUAD 80FPM
2
SLOW QUAD 60FPM
3
FAST SINGLE 375FPM
4 FACTORY DEFAULT
MEDIUM SINGLE 115FPM
5
SLOW SINGLE 60FPM
6
FAST DOUBLE 115FPM
7
SLOW DOUBLE 60FPM
8
FAST SIX 80FPM
9
SLOW SIX 60FPM
10
VARIABLE RATE SINGLE
11
NFPA QUAD 75FPM
12
CYCLE FLASH