Code 3 SuperVisor TL for Chevy Impala - Manual (Page 11)

11
PROBLEM
LED module not
operating when
powered.
POSSIBLE CAUSE
a. Bad power/ground
connection.
b. Defective module.
SOLUTION
a. Fix connection.
b. Replace module
Follow the guide below for information on repair and troubleshooting.
TROUBLESHOOTING GUIDE
Troubleshooting
All SuperVisors are thoroughly tested prior to shipment. However, should you encounter a problem during installation or during the life of
the product, follow the guide below for information on repair and troubleshooting. Additional information may be obtained from the factory
technical help line at 314-996-2800.
Note: LED modules must be replaced as a module. There are no user serviceable parts.
QUESTIONS
N/A
CycleFlash (DEFAULT) Quad Pop Flash75
NFPA QuadFlash75 Triple Pop Flash75
Steadyburn SingleFlash375
ModelFlash SingleFlash250
ActiveFlash SingleFlash150
FiveFlash70 FiveFlash150
QuadFlash70 QuadFlash150
TripleFlash70 DoubleFlash150
DoubleFlash70 TripleFlash150
SingleFlash75
Flash Pattern Header for OPTIX/LEDX
J1
Momentarily short and release
to change patterns
Directional module Flash Pattern - Table 2