Code 3 Sprinter - Manual (Page 17)

SPECIFICATIONS AND MAINTENANCE:
Specifications:
Siren Section
Input Voltage 10-15VDC (negative ground)
Input Current 10 Amps @ 13.6VDC
Output Voltage Maximum 100W @ 12VDC
Operating Temperature -30 °C to +65 °C
Dimensions (HWL):
Handheld controller 0.65”X 2.0”X3.7”
Amplifier 2.0″X3.6″X7.6″
Weight – Siren (approx): 4.0 lbs
Weight – Controller (approx): 0.5 lbs
Base: Black powder coat painted aluminum extrusion
Mounting – Siren: 4-hole flange mounting on base
Mounting – Controller: (Not specified), (4 mounting holes provided on base)
Compliance: SAE J1849, California Title 13
Warranty: 5 years
Maintenance:
Your Code 3 siren has been designed to provide trouble free service. In case of difficulty,
consult the Troubleshooting Guide of this manual. Also check for shorted or open wires.
The primary cause of short circuits has been found to be wires passing through fire walls,
roofs, etc. If further difficulty persists, contact the factory for troubleshooting advice or
return instructions.
Public Safety Equipment, Inc. maintains a complete parts inventory and service facility
at the factory and will repair or replace (at the factory’s option) any unit found to be de-
fective under normal use and in warranty. Any attempt to service a unit in warranty, by
anyone other than a factory-authorized technician, without the express written consent
of the factory, will void the warranty.
Units out of warranty can be repaired at the factory for a nominal charge on either a flat
rate or parts and labor basis. Contact the factory for details and return instructions. Pub-
lic Safety Equipment, Inc. is not liable for any incidental charges related to the repair or
replacement of a unit unless otherwise expressly agreed to in writing by the factory.
17