Code 3 Sprinter - Manual (Page 16)

PROGRAMMING STEP #7:
ENABLES PROGRAMMING OF THE EMERGENCY key:
the following keys will be illuminated:
EMERGENCY (will be illuminated Indicating Step #7 in Pressing any key
along with other any programming mode. in EMERGENCY
other keys programmed programming mode
into the light list.) will include that key
function in the list
of functions for the
EMERGENCY key.
Headlight Flasher:
If the vehicle is equipped with a headlight flasher, pressing both the left and right arrow keys
at the same time will enable this function when the EMERGENCY key is selected and will
illuminate the ALT key to indicate such.
Intersection Lights:
If the vehicle is equipped with intersection lights, pressing both the SEC & TAKEDOWN keys
at the same time will enable this function when the EMERGENCY key is selected.
(No indication is displayed for this function.)
Changing the initial condition of the SIREN tone from WAIL to YELP
Can be done by pressing the key to the following conditions:
WAIL/YELP key; Illumination condition: OFF Indicates: Siren tone off
Illumination condition: ON Indicates: setting to WAIL tone
Illumination condition: FLASHING Indicates: setting to YELP tone
When finished
press ALT to save
settings or to exit
without saving press
CLEAR.
TROUBLE SHOOTING:
PROBLEM PROBABLE CAUSE REMEDY
No siren output shorted speaker or speaker wires check connections and wire ways
Fuse Blows amplifier wires reversed polarity check polarity of wire connections
Siren tone volume low or garbled low voltage to siren amplier, high
resistance in wiring/ defective spkr.
check wiring for bad connections,
check spkr wiring, replace speaker
High rate of speaker failures high voltage to siren, 58 W speaker
connected-(58 W spkr not allowed)
check vehicle charging system,
install 100W speaker in system
Backlight will not light or adjust parklight input must have +12V for
backlight to function on controller
engage parklights on vehicle if
wired into system. or apply +12V.
to parklight circuit input on Amp.
Auxiliary lights do not operate IE:
alley, TD , sign board, headlight
flashers
short ciruit of wiring for light in
question, internal fuse blown in
amplifier
check wiring and connections to
lights in question, check and re-
place fuse in amplifier circuit
16