Code 3 Ranger - Manual (Page 8)

8
Maintenance
Lens cleaning
Use plain water and a soft cloth, or Code 3® lens polish and a very soft
paper towel or facial tissue. Because plastic scratches easily, cleaning is
recommended only when necessary (about every six months). Do
not subject the lenses to car washes that use brushes, as these will
scratch the lenses.
Lens Removal
First, disengage the lens clips (4 per lens) as shown in Figure 5 . Finally,
insert a screwdriver into the small slot in the lens clip pocket or the lens edge,
and twist the screwdriver to lift the lens.
FIGURE 5
Twist to
Lift Lens Pry Up to
Remove
Lens Clip
Light Head Removal and/or Lamp Replacement
Directional/corner: Remove screws securing the light head assembly to the frame, lift light head assembly, and then remove the
control wire (s). Reference Figure 6.
LED TD/Alley: Remove the two screws securing the light head assembly to the frame and the one screw from the black ground wire,
lift light head assembly, and then disconnect the red wire from the control wire by decoupling the quick slides (make sure to pull on
the quickslides only, not the wires). Reference Figure 6.
FIGURE 6
Troubleshooting
All lightbars are thoroughly tested prior to shipment. However, should you encounter a problem during installation or during the life
of the product, follow the guide below for information on repair and troubleshooting. Additional information may be obtained from the
factory technical help line at 314-996-2800.
Alley light assembly when no
corners on light bar.
DS Alley light
PS Alley light
PS Rear Corner
Rear Directional
Rear Directional
DS Rear Corner
DS Front Corner
Front Directional
Front Directional
PS Front Corner
Take Down Lights