Code 3 Quadrant LED Mini Bar - Manual (Page 2)

2
Installation & Mounting
Magnetic Mounting:
The magnetic based beacon provides a secure, temporary installation. The beacon should be placed in the center of the roof
where the least amount of curvature occurs. Check the magnet for debris before installation. Any foreign matter can reduce
holding power and scratch the vehicle. The roof surface should be dry and have a dull, not glossy finish. A glossy, highly
waxed surface will reduce the magnet's holding power. When placed, the beacon should adhere firmly. The user should not
attempt to drive with the beacon in place should the unit slide or move easily.
Permanent Mounting:
The permanent mount beacon provides a secure, permanent installation. Remove the magnetic mounting hardware and use
the supplied permanent mount brackets and screws to mount the beacon in the desired location. Wire routing should be taken
into consideration when choosing a mounting location.
Wiring Instructions
All versions of the Quadrant LED Beacon are supplied with a 9' straight cord terminated with a Lighter Plug. The lighter plug
has a push-button switch which serves as both ON/OFF control and Flash Pattern change switch. This plug may be used in
either a 12VDC or 24VDC cigarette lighter outlet; rotate and push with reasonable moderate force to insure the best possible
connection.
Features and Specifications
Operating Voltage: 10-30VDC, Reverse Polarity Protected
WARNING!
T his device, when magnetically mounted, is not intended for use on a moving vehicle.
This product contains high intensity LED devices. To prevent eye damage, DO NOT stare ino light beam
at close range.
As with any magnetically-mounted warning device, its use on the exterior of a moving vehicle is at the sole
discretion and responsibility of the user.
This magnetic mount product provides a secure, temporary installation in most circucumstances and is recom-
mended for stationary use only.
WARNING!
The use of this or any warning device does not insure that all drivers can or will observe or react to an emergency
warning signal. Never take the right-of-way for granted. It is your responsibility to be sure you can proceed
safely before entering an intersection, driving against traffic, responding at a high rate of speed, or walking on
or around traffic lanes.
The effectiveness of this warning device is highly dependent upon correct mounting and wiring. Read and follow
the manufacturer’s instructions before installing or using this device. The vehicle operator should insure daily that
all features of the device operate correctly. In use, the vehicle operator should insure the projection of the warning
signal is not blocked by vehicle components (i.e.: open trunks or compartment doors), people, vehicles, or other
obstructions. This equipment is intended for use by authorized personnel only. It is the user’s responsibility to
understand and obey all laws regarding emergency warning devices. The user should check all applicable city,
state and federal laws and regulations.
Code 3 , Inc., assumes no liability for any loss resulting from the use of this warning device.
Proper installation is vital to the performance of this warning device and the safe operation of the emergency
vehicle. It is important to recognize that the operator of the emergency vehicle is under psychological and physi-
ological stress caused by the emergency situation. The warning device should be installed in such a manner as
to: A) Not reduce the output performance of the system, B) Place the controls within convenient reach of the
operator so that he can operate the system without losing eye contact with the roadway.
Emergency warning devices often require high electrical voltages and/or currents. Properly protect and use cau-
tion around live electrical connections. Grounding or shorting of electrical connections can cause high current
arcing, which can cause personal injury and/or severe vehicle damage, including fire.
PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN THE PROPER USE OF EMERGENCY
WARNING DEVICES IS ESSENTIAL TO INSURE THE SAFETY OF EMERGENCY PERSONNEL AND THE
PUBLIC.
WARNING!