Code 3 OsciLaser Rear Deck/Dash Mount - Manual (Page 4)

4
ADJUSTABLE MOUNTING BRACKET
FIGURE 3
Maintenance
If necessary, maintenance of your OsciLaser
involves the cleaning of the lens and the replace--
ment of the lamp on the OsciLaser assembly.
Cleaning
Clean with soap and water to remove all salt, dirt or
mud. Do not use any abrasive cleaners or harsh
chemicals, because the polycarbonate lens will scratch
very easily. Polish the lens with PSE lens polish and a
soft paper cloth or towel.
Changing Lamps
To remove the lens, remove the 4 corner #8 x 5/8"
stainless steel screws. Using a glove or cloth for hand
protection, push in the defective lamp and turn counter
clockwise until the lamp can be removed. Install a new
Osram 64170 AX or equal bayonet-base lamp (non
ceramic base lamps are recommended) and replace
lens.
Lamps are extremely hot! Allow to cool completely before attempting to remove. Gloves
and eye protection should be worn when handling halogen lamps as they are pressurized
and accidental breakage can result in flying glass.
12
WARNING!
!
3) Peel the protective paper backing from one side of a piece of the double-sided tape and stick it to the top of
the bracket, (See Figure 3) for modes with adjustable mounting brackets.
4) Peel the remaining side of the paper and attach the bracket to the Oscilaser .
5) Peel the paper backing from one side of the other piece of double-sided tape and stick it to the bottom of
the bracket.
6) Remove the remaining side of paper and adhere it to the desired surface.
WIRING THE OSCILASER:
1) Using one of the supplied butt splices, connect the red power wire to the appropriate switched positive(+)
lead from the lighting control.
2) Using the remaining butt splice, connect the black ground (earth) wire to the vehicle chassis or a negative (-
) wire lead.
(For fusing purposes, each Oscilaser draws approximately 4 amps.)
When mounting the OsciLaser TM units inside the vehicle on the rear deck, make sure they
are securely fastened so that in the event of a collision they do not break free and injure the
vehicle occupants.
WARNING!
!