Code 3 MC SuperVisor Impala - Manual (Page 4)

4
Step 5 Mounting the SuperVisor
®
Remove the small Torx screw holding the rear view mirror to it's mounting bracket (See Figure 11), then push the mirror up and off of the mounting
bracket. Pinch the small terminal retaining clip (See Figure 12) and unplug the power wire to free the mirror. Once all four sun visor brackets are
attached and the rear view mirror is removed, the SuperVisor is ready to be installed. Route the power cable across the top and along the pas-
senger side of the SuperVisor, then route it through the notch provided on the front and passenger side front of the outer panel. This will prevent it
from interfering with the head liner or the windshield during installation. Carefully move the SuperVisor into position by tilting one end up as shown
in Figure 13, then swing the other end up into position being careful not to scratch the Impala's plastic corner post covers. Line up the mounting
holes in the Inner Mounting Brackets with the threaded holes in the SuperVisor and loosely thread the supplied 1/4"-20 bolts and internal tooth lock
washers into the holes in the SuperVisor's Outer Panel as shown in Figure 14 (Note: It is helpful to have an assistant pull down on the Inner
Mounting Brackets while you push up on the SuperVisor to help in aligning the holes). Tighten the two center inner Torx mounting screws as
shown in Figure 15. Tighten the two 1/4-20 bolts at the Inner Mounting Brackets (see Figure 16). Line up the mounting holes in the outer mount-
ing brackets with the threaded holes in the SuperVisor and thread the supplied 1/4"-20 bolts and internal tooth lock washers into the SuperVisor's
Outer Panel (see Figure 17). Tighten the three Torx screws in each of the two outer Pivot Brackets as shown in Figure 18. While pushing up on the
SuperVisor's Outer Panel, tighten the 1/4-20 bolts in the Outer Mounting Brackets (see Figure 19), then Replace the Plastic Visor Pivot Bracket
Covers.Plug the power wire back into the rear view mirror, reattach it, and retighten the Torx screw to secure the rear view mirror.
FIgURE 11 FIgURE 12 FIgURE 13
FIgURE 14 FIgURE 15 FIgURE 16
___
_______________
RETAININg CLIP
___
___
___
Caution: Drilling into the housing of the light bar could damage wiring or other internal
components.
FIgURE 17 FIgURE 18 FIgURE 19